|
|
| Samian A ware. Part of flat bottom, and of side, preserved to full height at one place. Mended from two pieces. From late wall (t). Leica ... 21 April 1932 |
| Inscribed fragment of columnar grave monument.
Broken top and bottom.
Portion of the curved surface preserved; inscribed near upper edge.
Hymettian marble. Found at a modern level, at the north foot of ... 21 April 1932 |
| Inscribed fragment of large columnar grave monument.
Broken top and bottom.
Portion of curved surface preserved represents somewhat less than half the circumference and bears part of the right side of ... 22 April 1932 |
| Carefully finished with three large holes on one side and one on the other.
Hellenistic group D. Pithos. Leica, 83-385, 99-38-10, 99-38-11 1242 ... 22 April 1932 |
| Square.
Apparently undecorated. Pithos.
150 B.C. Leica ... 22 April 1932 |
| Broken above and at both sides; back very rough-picked.
A standing female figure in girt peplos, head and left arm missing, is seen behind a semi-draped, probably male figure, seated right, with back and ... 21 April 1932 |
| Two fragments preserving handle and parts of offset rim.
Glazed inside and out; rim decorated with lines inside. Stripes on rim and three white lines around the body.
Red glaze and white paint are both ... 22-23 April 1932 |
| Mended from two pieces; most of one side of rim and side gone. Flat, spreading foot; high stand upon which sits a bowl with projecting ridge at the middle of the sides, pierced twice on either side, by ... 21 April 1932 |
| Fragmentary. Mended from many pieces; restored in plaster. Flat bottom; very short neck; band handle.
Greenish-buff clay. Unglazed.
Coarseware. Cistern, south chamber. Leica, 96-1-16 ... 22 April 1932 |
| Four non-joining fragments: a) floor to rim fragment, b) rim fragment, c) wall fragment and d) floor fragment. Flaking badly. Broad plain flat floor; low steep wall curving out to a thickened triangular ... 22-23 April 1932 |
| Two joining fragments make up whole of base (a) and part of wall and rim (b). Slightly hollowed base with small molding, shallow lower part; high vertical wall with uneven groove above carination at bottom; ... 22-27 April 1932 |
| Single rim to base fragment. Flat base, rough on bottom; straight steep wall; slightly thickened rim with deep groove on top.
Maroon-red ware, rather coarse. Thin purplish-black wash(?) on interior.
"Orlo ... 22-27 April 1932 |
| On rim, herringbone.
On discus, whirling rosette.
Handle solid, double grooved.
Nozzle set off from rim by two diagonal lines; no air hole.
On bottom, double almond-shaped grooves, enclosing palm branch ... 22 April 1932 |
| On rim, herringbone pattern.
Small, plain discus, concave, with central filling hole; two large circles at base of handle, balanced by two more on either side of air hole at back of nozzle.
Handle solid, ... 22 April 1932 |
| Ball-shaped body; slightly flattened on top.
Rim consits of narrow raised band round filling hole, set off from body by a broad and a narrow groove.
Neither handle or knob.
Rather small, deep nozzle and ... 22 April 1932 |
| Nozzle broken away.
Thick watch-shaped body, approaching double convex. Ribs, much worn, radiated over upper part of body from the small top, which consists only of a shallow groove round the filling hole ... 22 April 1932 |
| Vertical band handle and the left side of the body are broken away.
Watch-shaped body, flattened on top, with radiating ribs covering the upper part, from a small raised ring round the filling hole.
On ... 22 April 1932 |
| Vertical band handle broken away.
Watch-shaped body; the upper part covered with ribs which radiate from a sunken band round the filling hole.
Long, pointed nozzle; two grooves on top.
On the left side ... 22 April 1932 |
| Mended from many fragments; incomplete. Vertical band handle broken away.
Thick watch-shaped body, tending to double convex.
Long, pointed nozzle, rounded on top.
On the right side of the body, a small, ... 22 April 1932 |
| Sharply double convex body, with large solid knob on left side.
On top, wide raised band, sloping down toward filling hole.
Long nozzle, rounded at end, the nozzle broadening toward the tip, where the ... 22 April 1932 |
|
|
